Salter-brecknell APD-100 User Manual download pdf (Page 22)

22 APD-100 Automatic Powder Dispenser User Instructions

Operating the APD-100

5. Press the EXIT key to exit from memory and return to the standard weighing

and dispensing mode.

Recall a load using Memory Location Number

1. Press the RECALL key…

C=__ is displayed.

2. Press the MEM# key…

MEM.--- is displayed.

3. Key in the memory location number and press the ENTER key…

The cartridge information stored at that memory unit is displayed briefly,

then the load information scrolls over the display. See the note below.

4. Press the ENTER key to dispense this load.

5. Press the EXIT key to exit from memory and return to the standard weighing

and dispensing mode.

4.4.3 Edit Stored Information:

1. Recall a memory to edit using one of the methods discussed in the previous

sections.

2. Press the EDIT key to edit the cartridge name, powder or weight.

3. Press the ENTER key to accept the cartridge name, powder and weight.

4. Press the CANCEL key to clear the entire entry or press the BACKSPACE key

to clear the last number or letter.

5. Enter the new information as needed and press the ENTER key repeatedly

until the next cartridge name appears.

6. Press the EXIT key to exit from memory and return to standard weighing and

dispensing mode.

4.4.4 Delete Stored Information

1. Recall a memory using one of the methods discussed in the previous sections.

If the selected location is not correct or there is no data stored in it, NO MEM is

displayed.

WARNING: Be sure that the correct powder is in the reservoir

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Salter-brecknell APD-100 User Manual Page 22