p/n AWT35-500140 Issue AB July 2007 MODEL B 120 Counting ScaleUser Manual
84. Place the items to be counted on the scale…The total weight, piece weight and count of the items will be shown in the three display windows respec
98. Remove the items from the scale and repeat steps 7 and 8 to weigh the next batch of items.Counting with upper and lower limits can be done while u
105. The scale will not accumulate more than 999,999 times, or show an accumulated quantity over 16,777,215. If this occurs the display will show ----
11Access to the calibration switch may be sealed with a lead-wire combination on the bottom of the scale. Prior to removing the lead seal, check to se
126. Press the Enter key to confirm the zero point again.The scale goes through the start up routine and ends in normal weighing mode. If there is any
137.0 Setting the Auto-Off TimerYou can set an auto-off timer so that the scale will power down automatically after a period of inactivity. This funct
149.0 Displayed Messages ¯ ¯ ¯ ¯ ¯ ¯ Scale overloaded - - - - - - Too many accumulations or accumulated counts too high _ _ _ _ _ _ Weight signal is t
1510.0 SpecificationsPower supplya). 12VDC 500mA output, with positive center, AC adapter b). 6V4A rechargeable lead-acid batteryAverage working curr
16
UK and EUROPEBrecknelOP.O, Box 9533SmethwickWest MidlandsB66 2TETel: +44 (0) 870 444 6132Fax: +44 (0) 870 010 2241Email: [email protected]
B120_u_AWT35-500140.book WarningsSafe InstallationPluggable equipment must be installed near an easily accessible socket outlet.The socket outlet must
11.0 Introduction and General InformationThank you for purchasing the Model B 120 counting scale. Please read all operating instructions carefully bef
2Connect the red wire to the red battery terminal and the black wire to the black battery terminal.Place battery in the compartment with the padding p
33.0 Front PanelThe front panel, shown in Figure 1, consists of three display windows (WEIGHT, PIECE WEIGHT, and COUNT), the keypad, nine annunciators
4Key FunctionsEach of the keys shown in Figure 2 is explained below.Figure 2: B 120 keypad0-9 Used for keyboard entry of piece weight, sample size, an
54.0 Scale OperationThis section covers the various scale operations, such as weighing, counting, accumulation, etc.Simple Weighing1. Turn the scale o
6General Counting InformationIf there is no piece weight, the scale will not go into count mode.Once a piece weight is established, it remains active
74. Press the Enter key to accept the keyed in number. (If you make an error in keying in the number, press the Clear key to clear the count in the CO
Comments to this Manuals