Model PS3000 with SBI-100 Indicator Operation Manual
RS-232 data commands for SBI protocol The RS232 can be set so a bidirectional connection can be established between the indicator and the host. To e
Other RS-232 Output Strings P4-1 = Output Displayed data @ print key : Format: <LF>< reading, minus, decimal point, weight unit><CR&
Config Menu Avail. Settings Default Definition Detailed Setting P7 00-31 10 Displayed Resolution (00) = 500 (08) = 2400 (15) = 7000 (0
2. Tare 3. Tare 4. Enter in calibration weight from 5% to 100% full capacity 25%-100% kg/lb 5. Single point calibration,
Service Configuration Settings The scale is configured from the factory to match the specified settings for each unit, as defined by the product speci
Technical Specifications Scale Indicator Input signal range: 0mV ~ +30mV Sensitivity: >0.2uV/grad Internal Resolution: Approximately
Power Supply Connecting: Junction Box: 1. W1-W4: to adjust 4 corner error, W5-W6: not used 2. W0: to a
5. Connector pins: SH---shield wire EXC+ --- Excitation+ EXC- --- Excitation- SIG+ --- Signal + SIG- --- Signal - SEN+ --- Sense+ , connect to EXC+ SE
Declarations of Compliance United States This equipment has been tested and found to comply with the limits for a class A digital device, pursuant t
Safety and Warnings Installation and service THE EQUIPMENT CONTAINS NO USER SERVICEABLE COMPONENTS. Installation and maintenance of the equipme
Display and Keypad On/OffUnitsTareTkg/lbkglbHoldLow Batt CHACMaxd =-+SBI 100Zero0NETZeroHoldPrint Function Keys Annunicators TareTTare
Manual symbols Short Key Press Multiple Key Press Long key press Scale Operation Turning On and Zeroing
Removing the Tare On/OffZero 0Z ERO Hold function with automatic zero on next weigh. 1. Hol dPrint Hold 2.
Removing Hold Hol dPrint Hold Print Function For communications to a printer or PC, the indicator has to be setup in the following parame
USER CONFIGURATION SETTINGS Setup Controls Entering setup On/OffZero + Units Selecting parameter Tare Chan
User Configuration Settings Parameter Setting Default settings in bold P1.xy Auto shutoff timer in minutes Set up time for the auto off function.
Comments to this Manuals