Salter-brecknell 405 User Manual download pdf (Page 10)

7.0 Setting the AUTO-OFF Function

You can set the amount of time the scale is inactive before it shuts down

to save battery power. Follow these steps:

1. Turn the scale on. Press and hold down the Tare/Units key and the

On/Off/Zero key for more than 5 seconds until…

A.oFF.x” is displayed. X is the variable time in minutes. It can be

set from 0 to 9 minutes. If X=0, the AUTO-OFF function is

disabled.

2. To set the value of X, press the Tare/Units key to scroll through the

choices.

3. Press the On/Off/Zero key to accept the setting and restart the

scale.

8.0 Screen Messages

0¯¯¯¯¯¯: Power-on zero-point is more than 20% of full capacity above

the calibration zero-point when scale is turned on.

The weight reading is more than 5% of full capacity above the

power-on zero-point when you press the On/Off/Zero key;

0______: Power-on zero-point is more than 20% of full capacity below

the calibration zero-point when scale is turned on.

The weight reading is more than 5% of full capacity below the

power-on zero-point when you press the On/Off/Zero key;

_______: the current weight is less than –25% of full capacity;

¯¯¯¯¯¯¯: the current weight is over 102% of full capacity;

CAL-0: Zero point at calibration;

CAL-F: Full capacity at calibration;

CAL-Er: Calibration error;

A.ch.E r: Analog channel error;

EEP. Er: EEPROM accessing error or data in EEPROM is in error or

not in their normal range;

Lo.bAt: The voltage is below 5.7V (±0.1V)

x.x Udc: The voltage is x.xV (±0.1V)

1 2 ... 5 6 7 8 9 10 11 12

No comments

Salter-brecknell 405 User Manual Page 10